Home > Accessories >

Lower Parts Kit
ODIN Works Lower Parts Kit


 
Alternative Views:


Price: $59.00

Stock Status:In Stock
Product Code: ACC-LPK
QTY:

Description Prop. 65 Warning for CA Residents ยป
 
Complete lower parts kit.
Technical Specs
  • 31 piece set to complete a lower.
  • Machined parts, no MIM.
  • Hammer 8620 Steel
  • Trigger 8620 Steel
  • Disconnector 4340 Steel
  • Trigger Pin 4140 Steel
  • Bolt Catch 4340 Steel
  • Polymer Pistol Grip

Accessories
XMR 2 Extended Magazine Release XMR Extended Mag Release Clamp on Adjustable Low Profile Gas Block SB-PT Stabilizing Brace Pistol Buffer Tube
Price: $22.00

Add
Price: $20.00

Add
Price: $99.00

Add
Price: $79.00

Add
ODIN Works XMR GEN II Extended Mag Release ODIN Works XMR Extended Mag Release ODIN Works Clamp on Adjustable Gas Block ODIN Works SB-PT

Average Rating: 4.5 of 5 Total Reviews: 34 Write a review »

  0 of 0 people found the following review helpful:
 
Good kit December 27, 2018
Reviewer: Robert Henrich from Spokane Valley, WA United States  
Everything was snug and well made.  You'll have zero problems with this lpk

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
excellent except...... December 27, 2018
Reviewer: jeffery johnson from Marietta, GA United States  
Hammer spring too weak to ignite primers

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
December 11, 2018
Reviewer: William Ashley from Florence , SC United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Quality kit November 23, 2018
Reviewer: Tom from Quinlan, TX United States  
All parts seem top notch. For a basic milspec trigger, this is one of the best.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Works great aside from one potential minor issue. November 2, 2018
Reviewer: Anonymous Person from Knoxville, TN United States  
No missing parts and works great. Only a minor (potential issue) that may be caused by the Anderson lower. While pushing the hammer down with your thumb, until you let enough pressure off the hammer it will lightly grab the disconnector before returning to the ready to fire position. This doesn't impair function or even happen under a regular firing cycle, only when the bolt carrier or your thumb is pushing the hammer down while the trigger isn't being pulled. It's so light that I'd expect it to work itself out after some light use. If you really want, you could just lightly file the edge and it wouldn't touch the hammer at all. Again, no real problems and could be caused by the budget lower being a hair out of spec.

Was this review helpful to you?

View All Customer Reviews