|
|
|
|
|
EXCELLENT Addition to my Sig MPX Copperhead! |
March 5, 2019 |
Reviewer:
Neal Martin from Grand Forks, ND United States
|
|
The installation went smoothly as planned. Be sure to have a couple of very small pin punches available. The factory original pin smaller than 1/16". I used the same punch as I use for installing mag catch release pins in Milspec lowers. Being that the Odin Works pin is slightly larger, it tightens things up a little bit. Make sure it's well centered and give it a spray with Tri-Flow lube and wiggle it back and forth 100X or so while still clamped in the vise and it loosens up.
Was this review helpful to you?
|
|
|
|
|
|